R200/201P Bricked recovery oprions

I have over 20+ of these units that are in a locked state.

It begins its intial startup  then all lights stay on.

I know I cannot be the only one having seen this.

since the cost of replacement is cheaper than sending them in I have taken a few and started

to investigate options for recovery if possible.

I have noticed there are 5 pins located on the pcb. Is there a special interface needed for this to be able to

upload a new image to reflash the broken image?

Hi,

Could you please confirm if you have tried to Reset the devices using the Hard reset procedure:

http://community.cambiumnetworks.com/t5/cnPilot-R-series-R201-R201P/Resetting-R200-R201-to-factory-default-Hard-Reset/td-p/49765

Also tried using the ATA Analog Phone reset procedure : 

http://community.cambiumnetworks.com/t5/cnPilot-R-series-R201-R201P/How-to-reset-the-cnPilot-R200-201-using-a-ATA-Analog-Phone/m-p/53600#U53600

Regards,

Harish Krishna