For all PTP800/810 direct mount antenna, we offer a solution which can convert the antenna to PTP820 direct mount, so customer will be re-use the same antenna, no alignment need.
First, you will need order the PTP820 interface plate depends on which frequency the antenna is:
|N060082L004A||PTP 820 RFU-C interface plate for 6GHz ( CR4)|
|N070082L003A||PTP 820 RFU-C interface plate for 7GHz ( CR4)|
|N110082L003A||PTP 820 RFU-C interface plate for 11GHz ( CR4)|
|N130082L003A||PTP 820 RFU-C interface plate for 13GHz ( CR4)|
|N150082L001A||PTP 820 RFU-C interface plate for 15GHz ( CR4)|
|N180082L001A||PTP 820 RFU-C interface plate for 18GHz ( CR4)|
|N230082L001A||PTP 820 RFU-C interface plate for 23GHz ( CR4)|
Then you will need follow these steps:
Step 1: Remote the PTP800 ODU interface plate
Antenna with PTP800 ODU interface plate
after the interface plate removed
Step 2: install the PTP820 interfece plate follow the Andrew installation procedure (attachement)
Hello Allenyu! Does it work for another antenna makers? I see the part is Andrew but I'm using RadioWaves antennas.
Does this link answer your question?
I hope this helps!
Hehe! Yes, partially! Thanks! I only see for 11 & 18 GHz on RadioWaves. There's no 23 GHz?
Unfortunately there is no convert for 23 GHz today. It could be done but overall the demand is very low so far.