PMP 430 10 MHZ to 20 MHZ change

Somewhere I remember reading how to change the channel bandwidth from 10 MHZ to 20 MHZ on a 5.7 PMP 430. I have search everywhere i figure it would be, but no luck. Anyone here know what the procedure is.  Thanks  Dan

This would be under Configuration > Radio.

There should be a setting called "Channel Bandwidth".

I don't have a 430 online anymore that is handy to access... but that's where this setting has always been.

Changing this setting requires a reboot of the AP.

I can only think that maybe you're using a PMP 400 AP, which doesn't have the capability to change channel bandwidths... it only operated at 10 MHz.  If you post a screenshot, maybe that could shine more light on this.

Hi there ,

I can help u. 

Do u have skype ?

Don't have Skype at office.

The unit is a 5780 APUS.

For PMP430 Access Points you should use CNUT to change the channel size.

Click Update->Configure to pull up the following dialogue.

Capture.PNG

Under the HPAP tab goto the line for Current Bandwidth 10.0 and change the Target Bandwidth to 20.0.

Then do a firmware upgrade on your AP.

Note: You will want to configure all of your SM's for the new channel size first. (You should be able to do this through their GUI.)

4 Likes

Thanks Seth... it's been SO long I forgot about this.

Thank you very much. I knew I had seen this procedure before, but couldn't find it. Thanks for taking the time to help us.  Dan