Has anyone else seen this on their spec ans?
Just on AP side - so far
Did I miss a memo?
Sorry, Luis. What is it that you are seeing? (Maybe it should be obvious, but I am not the expert when it comes to Spectrum Analysis reports).
All the black bars. It should, or at least it used to, display a clean white background with the spectrum signal
One behind grey bars represent out of band frequencies, In range fequencies are the one in white back ground
This is an improvement added to help in selection of the frequencies.
In range - Out of range
Are you talking about the center frequencies (frequency carriers)? I'm assuming so, but you know what happens when one assumes.
Maybe a check box to toggle this improvement on and off? Maybe add the highlights below the signal graph? Like right on top of the frequency display itself?
I guess it's just my ADD, but this doesn't look so pretty good.
Thanks for listening