I have not been able to get any VoIP accounts to register with the C3VoIP-200 I am testing. Are there any existing setup examples that I could use for a reference?
Where is the Authentication Name entered for accounts that use it?
The quick start guide you linked to was not online a week ago when I got the device (And it is just an exerpt from the full manual you can get by contacting support). The C3VoIP-150 manual has similar information to the C3VoIP-20X manual... which was not very helpful (unlike typical Cambium manuals, which tend to be very helpful).
This helped some. I was able to get an account to register.
On a very basic account (Username, Password, Server), I got a successful registration entering:
Username -> Account AND Phone Number
Password -> Password
Server -> Proxy Server
If the matching username was not entered in both Account and Phone Number fields, registration failed. If either field was left blank, registration failed. All other settings were at defaults.
On another account that uses an Authentication Name and an Outbound Proxy, I could still not get a successful registration. I tried:
Username -> Account
Authentication Username -> Phone Number
Password -> Password
Server -> Proxy Server
Outbound Proxy -> Outbound Server
and
Username -> Phone Number
Authentication Username -> Account
Password -> Password
Server -> Proxy Server
Outbound Proxy -> Outbound Server
Both of these failed to register.
Any further thoughts on configuring an account that uses an Authentication Username?
I have two very basic setup examples to share. The port numbers should be adjusted as necessary. These show the bare minimum (using otherwise default settings) to get the system running. I've been operating both of these examples for about 1 month.
Basic:
The first example is for an account that uses a basic domain / username / password combination.
Ive notice the same interface GUI with the ReadyNet ATA/Wireless router I was hoping to be able to use my own TFTP or provision server, is there any documents showing Provisioning Parameters .. READYNET has them.