I am looking for the command to set the Channel Bandwidth FROM 20/40Mhz to force 20Mhz for 2.4. Anyone know what that command is?
Hi
“HT_BW=0” is configuration parameter to set the Channel Bandwidth FROM 20/40Mhz to force 20Mhz for 2.4 GHz. Please update this parameter in config file then upload/ push configuration using cnMaestro/TFTP/HTTP provision.
Regards
Niraj
I have E410 with latest firmware
I already set to 20MHz channel width as below
wireless radio 1
no shutdown
channel 5
channel-width 20
Do I need to add another HT_BW=0 in config?
tq
Hi nbctcp
This post is about R series cnpilot AP.
For E series (E410) no need to execute any command apart for GUI settings for channel width.
Best Regards,
Gupta