Hi
I hope someone can shed some light on a strange issue I am having.
I am testing the provisioning of cnPilot R190 routers, W and V versions, both on latestest software.
We have a default provisioning vlan setup, with dhcp that adds the device to Maestro, then once provisioned the port is chnaged to 2 vlans, a PPPoE broadband vlan and a management vlan
This all works just fine... kind of.
If I look at the router config file it all looks right, the wan connect type is PPPoE, the username and password is there, I can ping the managemnt IP but i never see an authenticate request hit my radius server, and now for some reason I cant connect to the management interface via a browser, not from the inside or outside, i.e. not even from the default 192.168.11.x range to 192.168.11.1, not cable or wifi.
To make things worse if I factory reset the device and plug my notebook into LAN 2 or 3 or whatver I get an IP via the routers DHCP service I can ping .1 but even at factory default I dont get a login screen, i cant even telnet to the cnPilot on port 80
But even in the defaulted stage I can get the unit to reconnect to cnMaestro if I set the provisioning vlan on the switch port that the wan cable connects to, and then I can provision and send it config information, reboot, upgrade or downgrade firmware etc, once again i can ping the management IP but cant connect to it via port 80, not even from abother device in the same vlan / LAN range as the management IP, so no firewall issues
I have a W and a V version, both are doing the same thing
Any ideas or suggestions would be appreciated