When using 3.4.1 or 3.5 on the masters the customer units are only connecting to the sector, not the antenna. After a reboot and customer units will connect and use the antenna but only for a limited time before all are back on the sector.
Reverting back to 3.2.2 fixes the problem. I looked through the firmware notes but didn't see any mention of this.
Somehow I missed this other post but it seems to be the same/similar issue.
When using 3.4.1 or 3.5 on the masters the customer units are only connecting to the sector, not the antenna. After a reboot and customer units will connect and use the antenna but only for a limited time before all are back on the sector.
Reverting back to 3.2.2 fixes the problem. I looked through the firmware notes but didn't see any mention of this.
Somehow I missed this other post but it seems to be the same/similar issue.
I know this is an older post but the issue is still happening on all of my epmp 2000 units with the beamforming antenna. I sent you an email last week to see if we can arrange a remote session to troubleshoot, currently all the access points are on 3.5.1
75/25 , 2.5 ms, 20Mhz channel width. There is a ticket up for this problem, currently i'm letting the ap's report to a syslog, and will send the information in after they revert the CPE's back to sector only.