Showing results for 
Search instead for 
Do you mean 
Reply
Highlighted
Occasional Contributor
Posts: 5
Registered: ‎08-17-2017

SM WIFI does not find available wifi SSIDs

Hi,

 

I am new to epmp. I have a question on how to configure SM module in Wifi mode so it can scan for available wifi routers / SSIDs in my office. Right now, Monitor - Wireless shows Operating Frequency as Scanning... and no Available APs are found...

 

What configuration should I do?

 

Thnx.

Contributor
Posts: 33
Registered: ‎01-19-2016

Re: SM WIFI does not find available wifi SSIDs

Obviously you need a 2g or 5g depending on what wifi you are connecting. When you set it to WiFi mode, you have to reboot it after setting that before monitor wireless shows the wireless SSID's

Occasional Contributor
Posts: 5
Registered: ‎08-17-2017

Re: SM WIFI does not find available wifi SSIDs

I've tried rebooting the SM a few times. The Radio Mode is SM & Driver mode is Standard Wifi. I have not added any preferred APs, and I have selected All the frequencies in 5, 10, 20, 40 MHz scan lists. Rest options are all defaults..

Contributor
Posts: 33
Registered: ‎01-19-2016

Re: SM WIFI does not find available wifi SSIDs

Oh what firmware? there was an older firmware that didnt allow Wifi mode to work

Occasional Contributor
Posts: 5
Registered: ‎08-17-2017

Re: SM WIFI does not find available wifi SSIDs

The SM is on current version 3.5..

Moderator
Posts: 771
Registered: ‎09-28-2014

Re: SM WIFI does not find available wifi SSIDs

Which AP are you going to connect?

Can you see it with Spectrum Analyzer?

 

Thank you.