I just upgraded a few APs from 3.1 to 3.5. I found a bug that seems to only happen in the older intergrated and connectorized radios while doing some cpe swaps. When configuring the radio, the coordinates won't allow any decimal places. No issues with Force200 and 180. So in cnMaestro it shows some people in the middle of lake Erie. The ones that were already configured before the firmware update are fine.
EDIT - i just found the post about clearing cookies, which is a pain
NewKirk posted an answer in another thread about this - a trick to clear cookies just from specific sites. For me, all my ePMP's management IP's are all on our 10.x.x.x network, so it's easy-peasy to match that and delete just my ePMP cookies, so NewKirk posted this. This is still a bit of a pain, but MUCH less painless than clearning all the cookies browser wide.
When configuring the radio, the coordinates won't allow any decimal places. No issues with Force200 and 180. So in cnMaestro it shows some people in the middle of lake Erie. The ones that were already configured before the firmware update are fine.
Thanks
Jake
Same Issue with Force 180 and Force 200 - Tried using Firefox and then Chrome suspecting that might be a JavaScript issue but i got identical results.
It seems this problem is not limited to ePMP 2000 AP's. This last week I started rolling out 3.5 to our network. I've lost access to 2 ePMP 1000 AP's with the exact same scenario: Inaccessible by LAN but accessible by wireless at close range, no MAC visible in the switch. Rolling back to 3.4.1 and the AP returns to normal operation. I've not noticed a problem on subscriber units yet.
In version 3.5 Rc7 had been mentioned a fix for random reboot, because in the final version did not mention anything about this problem? I am using version 3.5 Rc7 in an ptp and so far no longer presented the problem."
"
Hi Alex,
It was probably missed in the release notes update. All defect fixes in 3.5-RC7 are in the official 3.5 release.
Thanks,
Sriram
"
May I ask what are the simptons for this behavior? Thank you for your answer.
The AP (epmp2000) first has caused poor link towards SMs then kicked them all out ofetr some days of struggeling woth intereferences that previously has been handled quite well with same equipment.
Is anyone of you guys encountering the same issue?
p.s.
I downgrade only AP to 3.4.1 and everything turned to normality and the SMs are now on the AP worjking regularly.
I just noticed that the preferred AP wasn't saving in the radios, I made the change in several radios and hit save. Now they hit the AP, but are not even asking for radius authentication. I have tried a reboot on customer side, no help. I changed the AP to WPA2 instead of radius, still nothing. have tech in route to look now. Has anyone had issues like this before?
tech onsite had to remove the preferred AP setting to fix. anybody else have issues with this?
I have updated several APs with 3.5 I have complaints from customers who often have no connection, they have to restart sm to reconnect, sm mounts only 2.6 AP 3.5
I just bought 3 ePMP 1000's. They all have 2.6.2-RC250 installed. I have attempted to download 3.5 GPS Sync as well as the full package and neither firmware will download. I get two intilizing firmware messages. One in blue and the other in red. Can anyone help?