epmp 1000 reboot error after changing mode from SM to AP

Dear team!,

My epmp 1000 intergrated has some problem .detail as bellows. please help me

Before.

1.can’t login with admin/admin after even hard reset( webbase’s showed)

After trying to fix

1.i can login with admin/admin ( sm mode ) after resetting by pluging in and out the power ethernet cable for 4-5 times. But when I change mode to access point then reboot, I can’t access even more ( http to 169.254.1.1 or 192.168.0.1) the webbase config does not show up.

My devices’s using software 3.5.1 and U-Boot 9344_PX 1.1.4.e (Sep 21 2016 - 11:55:11).

1 Like

I have forwarded this to the development team. You should have an answser here soon.

1 Like

Hello bao,

Regardless of configuration, the device should be accessible using the fallback ip address 169.254.1.1. Can you access the device via ssh?

Regards

3 Likes

hello sir,

before the device can not log in by any account any protocol even after hard reset by hiting on the button 

after resetting by pluging in and out.i can login with ID admin/admin, it's performance like normally.i can login by http, telnet.but there's some problem

1.the device work well with SM mode

2.work with mode AP ePTP

3.error happened when i changed to mode AP TDD PTP or AP mode TDD then reboot to apply configuration. i could't login again the webbase did not showed up.(cleared cache on browser)

anyone who can help me?

Hi,

Is only one unit affected?

Thank you.

I have exactly the same problem...

hello sir,

before the device can not log in by any account any protocol even after hard reset by hiting on the button 

after resetting by pluging in and out.i can login with ID admin/admin, it's performance like normally.i can login by http, telnet.but there's some problem

1.the device work well with SM mode

2.work with mode AP ePTP

3.error happened when i changed to mode AP TDD PTP or AP mode TDD then reboot to apply configuration. i could't login again the webbase did not showed up.(cleared cache on browser)