02-17-2017 07:52 AM
From what I gather XM is just bad and shouldn't be expected to work (session drops, GUI is slow, 5-15 minutes for a firmware change).
So now I'm debating how I should fix this.
1) Replace XM with XW beams, then elevate
2) Set Rocket to Wifi, replace XM with Force200, then elevate
3) Elevate, then replace XM radios with Force200
Has anyone gone through this decision and can you share your experience/ideas?
02-17-2017 08:49 AM
So far, I've just been elevating everything and then replacing the XM radios as needed with Force200.
I would say that around 75% of our XM radios are working fine, so they just get left alone unless problems show up, but the ones that keep dropping sessions constantly get replaced.
Each option has it's own upsides and downsides. Replacing everything with XW is probably going to be the least disruptive, but long term I'd rather have Force200s out there than elevated PowerBeams. The cost of a PowerBeam + elevate license is almost exactly the same as a Force200.
I think a big part of which is the best way to go comes down to how many XM radios are on an AP... and how many total radios, for that matter.