Defect Fixes (System Release 3.2)
Tracking |
Description / Workaround |
13124 |
Throughput Chart is not synchronized with time configured on the device |
13104 |
Incorrect validation warning displayed for Management VLAN ID field on SM |
12627 |
SSH server upgrade to prevent false positive reports of vulnerability |
12922 |
Updates to prevent SM disconnects in high subscriber-count deployments |
13138 |
Updates to Device Latitude and Device Longitude field auto-correction mechanisms |
12892 |
Wrong System Description in LLDP message from ePMP device |
12890 |
Browser āBackā button does not work properly with ePMP web management interface |
12874 |
5.2 GHz/5.4 GHz bands not supported for New Zealand country code |
13172 12814 |
After configuration file restore, reported count of logged-in users increments by one after each device reboot |
11987 |
When more than two DNS IPs are obtained using DHCP, the third and subsequent DNS IPs will get truncated when displaying on the GUI. |
Ā Ā
Known problems or limitations (System Release 3.2)
Tracking |
Description / Workaround |
13165 |
SM in NAT mode with Separate Management IP and Management VLAN is not accessible by Separate Management IP address |
13289 |
Invalid warning appears on web management interface when Subscriber Module Target Receive Level is configured above -60 dBm |
13228 |
Web management interface is not accessible after an upgrade attempt with invalid software archive.Ā Workaround:Ā reboot the device to regain management access. |
13317 |
eDetect may not display interfering devices at lower received/detected power levels |
13187 |
Upon configuration restore, a browser refresh is required to display updated parameter values |
Pending |
[ePMP Elevate] ePMP Elevate subscriber may disconnect under load due to hardware limitations |
12791 |
[ePMP Elevate]Ā XM devices:Ā When downlink RSSI is stronger than -30 dBm, the web management interface incorrectly reports RSSI of 256 dBm and SNR as 0 dB |
12919 |
[ePMP Elevate]Ā Rocket M5 (XM and XW):Ā The web management provides options for configuring the device in AP or ePTP mode.Ā These modes are not supported by ePMP Elevate software and should not be utilized. |
13332 |
On accation, after upgrading an ePMP SM to Release 3.2, the SMās web management interface may display āBoard still in reboot stateā or the interface may not be accessible.Ā Workaround:Ā reboot or power cycle the SM. |