Defect Fixes (System Release 3.5)
|
Tracking |
Description |
|
14490 |
[ePMP 2000] Clock calibration between ePMP and ePMP Elevate devices |
|
14455 |
2nd Management interface obtains Fallback IP with VLAN enabled |
|
14771 |
Reliable Multicast parameters removed from ePTP mode |
|
14567 |
[Elevate] Automatic workaround to reset device when Elevate XW Nanostation Loco M5 subscriber Ethernet LAN port goes down |
|
10124 |
Ethernet watchdog error on SM |
|
14889 |
"\" symbol for DeviceName crashes web management interface |
|
14721 |
[Elevate] Unsupported Elevate models removed from MIB file |
|
13308 |
[Elevate 2.4] RADIUS GUI Authentication not functional |
|
14497 |
Erroneous validation failure between Lan IP address and Lan Gateway IP addresses |
|
14734 |
Fixed tcpdump vulnerability to gain root CLI access |
Known Problems or Limitations (System Release 3.5)
|
Tracking |
Description / Workaround |
|
14862 |
Link test error message when run with more than 28 SMs connected to ePMP2000 AP. Workaround: Restart the link test |
|
14868 |
Primary Frequency Carrier is not saved to .config file if ACS is started after selecting Country. Workaround: Device reboot or re-run ACS |
|
14866 |
Save and Undo buttons are highlighted after importing JSON/BINARY configuration with ACS Enabled. Workaround: Web management interface refresh |
|
14872 |
[Elevate 2.4] ePMP Elevate NanoBridge M2 XM always displays Ethernet Status Down. Display-only issue, Ethernet port is functional. |
|
14846 |
[Elevate 2.4] Error message 'Please perform device reboot before Upgrading software.' is shown on GUI during SW upgrade. Workaround: Web management interface refresh |
|
14888 |
LLDP neighbors are not seen by ePMP 2000 AP |
|
14772 |
"Applying" button is present for a long time in NAT mode if the Сommunity String has changed before. Workaround: Web management interface refresh |
|
14891 |
"Applying" button is present for a long time if IP address received from DHCP via VLAN interface with enabled LLDP. Workaround: Disable LLDP functionality |
|
14816 |
Switching IP assignment to Dynamic creates second user GUI session. Workaround: Device reboot |
|
14776 |
After reset to factory defaults SM in Standard WiFi mode cannot connect to AP configured in Standard WiFi mode on 20 MHz channel bandwidth. |
|
14894 |
Web management interface shows error message when trying to change IP address. Workaround: Device reboot |
|
14873 |
Cannot import binary configuration with non-valid License Key. |
|
14904 |
Wireless Gateway is shown as empty on ePMP SM web management interface if obtained from PPPoE server with Separate Management IP and VSA configured. |
|
14770 |
New IP Address cannot be assigned if the Community String has been previously changed. Workaround: Device reboot |
|
14906 |
Unable to force Sector Antenna on ePMP2000 AP via SNMP. Workaround: Use web management interface to force Sector Antenna |
|
14783 |
Admin password erroneously applied to Full AP radio after exporting configuration from Lite AP radio |
|
14873 |
Web management interface will not show error after importing binary configuration with non-value license key |