Has anyone else seen this? I had upgrade several 2460 radios from 8.1.5.1 to 8.2.1. One of them now thinks it is a BH20
Home
Configuration
Statistics
Tools
Account
PDA
Copyright
Login
Account: none
Level: ADMINISTRATORGeneral Status Event Log Network Interface Layer 2 Neighbors
Home => General Status
Canopy Lite - 2.4GHz - Subscriber Module - 0a-00-3e-24-77-d9 No valid accounts configured. Using default user account
Device Information
Device Type : Canopy Lite - 2.4GHz - Subscriber Module - 0a-00-3e-24-77-d9 No valid accounts configured. Using default user account
Software Version : CANOPY 8.2.1 BH20-DES
Software BOOT Version : CANOPYBOOT 1.0
Board Type : P10
FPGA Version : 091807
PLD Version : 9
Uptime : 00:02:59
System Time : 00:02:57 01/01/2001
Ethernet Interface : 100Base-TX Full Duplex
Antenna : Vertical
Subscriber Module Stats
Session Status : SCANNING VC 0 Rate 1X/1X
Registered BH : n/a
RSSI : 0
Power Level : Power Level not calibrated. Power Level not available.
Jitter : 0
Air Delay : 0 approximately 0.00 miles (0 feet)
Region Codes
Regional Code : United States
Site Information
Site Name : No Site Name
Site Contact : No Site Contact
Site Location : No Site Location
with version 8.2.1 on it the max power is 1 dbm, it has the 2.4 frequencies available, can be set to master or slave, etc just like a real BH20. When I go back to ver 8.1.5.1, it stays a BH20, but the freq list goes to custom and it is 5.150 to 5.350 instead of 2.4. I have not yet heard back from Tech support on how to fix this issue.
wow.
Isn’t that great? if you got another one… you got a pair now.
does it also have BH config page?
I just can’t seem to replicate it either.