I have a situation trying to work with Prizm-Bam 3.1 licenses.
I have 75 SM Lite 512 to 1000 licenses installed in my Prizm (I can see taht in Prizm Help>ShowLicensing>Bandwidth). I have “authentication required” enabled and “configuration source” setted to BAM in my AP.
However when licensed SMs connect to AP, I see at AP “session status” page the SMs with 512 (uplink+downlink) sustained data rate, but I already setted up this values to 700kbps sustained downlink + 200kbps sustained uplink in BAM:
Site Name : TEST Laboratorio
Software Version : CANOPY 8.2.7
Software Boot Version : CANOPYBOOT 3.0
FPGA Version : 061708 (DES, Sched, US/ETSIv1.3.1) P9
Session Timeout: 0, AirDelay 3 (approximately 0.03 miles (147 feet))
Session Count: 1, Reg Count 1, Re-Reg Count 0
RSSI (Avg/Last): 2076/2080 Jitter (Avg/Last): 1/1 Power Level (Avg/Last): -37/-37
Sustained Uplink Data Rate (BAM): 114 (kbit)
Uplink Burst Allocation (BAM): 111 (kbit)
Sustained Downlink Data Rate (BAM): 398 (kbit)
Downlink Burst Allocation (BAM): 222 (kbit)
Low Priority Uplink CIR (BAM): 100 (kbps) Low Priority Downlink CIR (BAM): 100 (kbps)
High Uplink CIR (BAM): 99 (kbps) High Downlink CIR (BAM): 99 (kbps)
Rate : VC 18 Rate 1X/1X VC 255 Rate 1X/1X
In BAM I see the following message: Failed to checkout CanopyLiteSMFrom512to2000V3 license for device 0A003EF5E09E. No chekout ocurred.
What is wrong? Why message says 512to2000 when I have 512to1000 licenses? Can anybody help me with that, please?
Thanks very much in advance,