BH configuration in the CMM ( both site master and slave )

please somebody can help me to get the normal and complete configuration for BH link.
i’m trying but it’s worring me a lot now.
i would like to get an help from all forum memebers.

best regards for you all.

thankx.

There is a quick start tab that will walk you through a basic setup. What kind of problems are you having? I would bench test/configure the units first then after validating that they can see each other I would install them. Are you using reflectors?

romaric wrote:
please somebody can help me to get the normal and complete configuration for BH link.
i'm trying but it's worring me a lot now.
i would like to get an help from all forum memebers.

best regards for you all.

thankx.



yes i'm using reflectors
Canopy_Support wrote:
What kind of problems are you having?


I dont understand your question. Is the link up but bouncing? Is it not able to register at all? Did you use a headset to align the radios or did you just point them in the general direction? Can you email your configs to technical support? There isnt enough information in your post. Email the configs with exact detail on your problem.