CBRS procedure for changing frequency

[ericmule]

For AP’s authorized in the SAS, what is the recommended method of changing frequencies in the AP?

I attempted to change frequency on a 30mhz channel via the AP GUI. It automatically deauthorized but after sitting idle for 5 minutes, it didn’t reauthorize. I gave up and reverted back to the original frequency without issue. Should I have waited longer and if the frequency does change is there anything that needs to be done in cnMaestro?

Fortunately, I haven’t needed to changed frequencies for CBRS AP’s until last night.

[Simon_King]

This question came up a few days ago:

Best Practices For Changing The Frequency On An Existing CBRS Enabled AP

Hello All, I was wondering if someone could point me in the direction of changing the Frequency on an existing CBRS enabled AP? I’m sure there is some documentation out there, but I have been unable to locate it. Thank You, Scott Pope Arbuckle Communications, LLC

According to that thread, you did the right thing, and perhaps simply didn’t wait long enough.

[ericmule]

Thanks Simon! I assumed it was that simple. I have no patience…so says my wife.