Channel Bandwidth

I am looking for the command to set the Channel Bandwidth FROM 20/40Mhz to force 20Mhz for 2.4.  Anyone know what that command is?  

Hi 

“HT_BW=0” is configuration parameter to set the Channel Bandwidth FROM 20/40Mhz to force 20Mhz for 2.4 GHz.  Please update this parameter in config file   then upload/ push configuration using cnMaestro/TFTP/HTTP provision.

Regards

Niraj

I have E410 with latest firmware

I already set to 20MHz channel width as below

wireless radio 1
no shutdown
channel 5
channel-width 20

Do I need to add another HT_BW=0 in config?

tq

Hi nbctcp

This post is about R series cnpilot AP.

For E series (E410) no need to execute any command apart for GUI settings for channel width.

Best Regards,

Gupta