CNPilot E410 in bridge mode

Hi! I'd like to know where do I change the cNPilot E410 to bridge mode? It will be linked to an ISP modem/router so do I need to configure SSID and password in radio or just in the modem?

Bridged mode is the default. Simply configure a WLAN with the SSID and WPA password on the E410.

The WLAN by default will be mapped to VLAN 1 and will be bridged to eth1 (which is an access port on VLAN 1 by default). In this mode your ISP's modem/router will be expected to serve IP addresses to the wireless clients over DHCP.

2 Likes