ePMP can't access

Products ePMP
1

Hello , 

I try to access > SM ePMP1000 ,

1- static IP

2- 169.254.1.1 .

3- Hard defult reset bottom .

but , notheng happen :(

IMAG0508.jpg 

2

Hi Alsahli,

Eth1 LED does not light up.

It means that device does not have Ethernet connection.(Data cable is not inserted or Eth interface is down).

Then you may try to reset device to default via Power Cycle.

Resetting the ePMP to factory defaults by power cycling

Operators may reset an ePMP radio to default factory configuration by a sequence of power cycling (removing and re-applying power to the device). This procedure allows operators to perform a factory default reset without a tower climb or additional tools. 

Procedure:

1

Remove the Ethernet cable from PoE jack of the power supply for at least 10 seconds.

2

Reconnect the Ethernet cable to re-supply power to the ePMP device for 3-5 seconds and disconnect cable to power off the ePMP device for 3-5 seconds. (1st power cycle)

3

Reconnect the Ethernet cable to re-supply power to the ePMP device for 3-5 seconds and disconnect cable to power off the ePMP device for 3-5 seconds. (2nd power cycle)

4

Reconnect the Ethernet cable to re-supply power to the ePMP device for 3-5 seconds and disconnect cable to power off the ePMP device for 3-5 seconds. (3rd power cycle)

5

Reconnect the Ethernet cable to re-supply power to the ePMP device for 3-5 seconds and disconnect cable to power off the ePMP device for 3-5 seconds. (4th power cycle)

6

Reconnect the Ethernet cable to re-supply power to the ePMP device for at least 30 seconds and allow it to go through the boot up procedure (Note: Device will go through an additional reset automatically). This will reset the current configuration files to factory default configuration (e.g. IP addresses, Device mode, RF configuration etc.). The device can be pinged from a PC to check if boot up is complete (Successful ping replies indicates boot up is complete).

7

Access the ePMP device using the default IP address of 192.168.0.1 (AP) or 192.168.0.2 (SM).

Or try to reach it on old default IP address: 10.1.1.254 if you are not sure device has FW version higher than 2.0.

Thank you.

3

Hi Fedor,

I did it , stil Eth1 LED off

4

Ethernet port may have been broken in the fail.


Thank you.