epmp wireless management vlan

when will the management VLAN problems be fixed ?

if you setup a SM with NAT be it either 2.3.3 or 2.3.4 or the new beta.

it seems the SM replies to the default gateway on the management interface.

here's an example.

if i use a computer in the same management vlan i cannot reach the SM

but after i try to reach the SM from the same vlan, the arp reply get's sent to the default gateway, which then allows me to reach the SM from a different network routed through said gateway.

this is REALY frustrating, as we are running alot of SM's in NAT mode.

Hi,

Could you please answer the folllowing questions.

- What is your VLAN(Data) ID?
- Do you have "Separate Wireless Management IP" enabled?
If so, do you have "Separate Wireless Management VLAN" enabled?
If enabled, what is the "Separate Wireless Management VLAN ID"?
- Where is the computer connected? Below the SM or Above the AP?

Thanks,

Balaji

VLAN DATA ID : 1 (not specified in config) we use vlan 1 for distribution of public ip

seperate wireless management ip : enabled

seperate wireless management ip : 172.16.224.100

seperate wireless management vlan : 224

seperate wireless management gateway 172.16.224.1

computer is connected above the AP (which also has management vlan of 224, but the ap has no issues)

using wireshark on the 224 vlan, i can see that arp replies from the SM gets sent to 172.16.224.1 instead of me and thus i cant access it.

but since  the gateway now has the arp of the sm stored i can access the sm from a routed network on the gateway.

so by pinging the SM on vlan 224 it "wakes up"

100% of our SM's behave this way and we have tried different firmware, 2.3.3, 2.3.4 and the new beta release

it seems this user has the same problem

reference : http://community.cambiumnetworks.com/t5/ePMP-1000/SM-Management-problem-in-2-3-4/m-p/37865#U37865