Help

Products PMP
#1

I can’t get wireless router working at my customer house. The Router gets the IP information but the computers dosnt do anything. I think is a setting in the sm or ap.

#2

what do you have filtered on the SM?

#3

Hey!

If the SM is natted (router gets the IP) then it’s unlikely it’s an SM filter.

I would suggest bypassing the router, going directly to one computer.

I’d even try a second (my own) computer, if the first (client) computer failed to connect.

In context, I would want to know if this is the very first subscriber on a given AP, or perhaps even a new tower/site installation.

All things being equal . . .

Bad ends/bad wire.

#4

If it is nat’d I have seen a router pull an IP on my internal network range, however there is still no connectivity.

#5

The SM is not NAT’ed The Customer Router gets the Public IP, and the computer gets the ip from router but it still doesnt go to the internet.

#6

whats filtered under the advanced network configuration?

#7

Its not the Router because I bypassed the SM and AP and it work instantly. It has to be the SM because I cant even ping it are login to it. But if i move the Router I log right into the SMt no problem.

#8

Ok my setup TRAFFIC MANAGER (10.0.0.1) - MASTER BACKHAUL (10.0.0.5) - SLAVE BACKHAUL (10.0.0.10) - AP (10.0.1.1) - SM (10.0.1.33) - CUSTOMER PC - 201.21.33.2

I found out if I put the customer on the 10.0.0.X it works fine,

Network is eth0
10.0.0.1 eth1

vlan 1.100 is 201.21.33.1

Please Help

#9

This is even Crazy, I found one router that works Linksys WKPC54G, the WRT54G, WRT54GS didnt work at the all. this is so weird.