It would be very helpful if the Status LED’s were visible from outside the units. This applies to all types.

hello Sir …

may I studied from you, about Canopy Wireless

The “LED” 2.4GHz - Multipoint - Subscriber Modem

LNK/5 and

"doesn’t work"

why ?

I’m trying to default plug with short the pin 4 & 6 connector RG-11
but “doesn’t work”


All the lights on every model I have used work. If the Link and Act lights don’t on yours I assume that you also cannot connect to the unit. If you use 568A or 568B you should be able to plug the unit into a computer and “talk” to it.

As for the default plug, you must insert it, power cycle the unit, and then it should be defaulted to factory settings.