1, how do i intergrate NAT and VPN in an SM,when there is a server and cisco PIX behind that SM that should be accessible to the remote VPN

2, how do i adjust power on the AP, SM and BH

please assist me


Canopy radios dont support VPN tunneling protocols (not sure about above 7.3). But if you turn off nat, it will work, just not through nat.

Right, you need a VPN appliance to handle NAT and the VPN tunnel - a Linksys RV082 will do the job.

How to set power on the AP, SM, and BH is in the manual

Motorola can’t figure out how to track SPIs across NAT so they just don’t support it. Even a $30 linksys box can do it…