Affected platforms: ePMP4500/ePMP4500C and ePMP4600 Affected versions: 5.8.0 and newer Starting with the 5.8 firmware, the ePMP4500/4500C (8x8) and ePMP4600 (4x4) devices leverage the advantages of a multi-chain hardware architecture to significantly improve downlink signals through beamforming. T…

Please reach out to me if you’d like to try Alpha firmware sooner than the official Beta firmware is released. Thanks.

Is QOS/MIR on the horizon for these platforms?

Yes, QoS/MIR control is in 5.8.

Can you send it to me or if that can be added to cnmaestro Thank you

Hello @PCaddict , in it availible in downloads beta section here It should be in CnMaestro soo.

[image] Fedor: Note: Beamforming gain is not reflected in the UI (the RSSI level doesn’t increase); it is observed only in the higher modulation and coding schemes (MCSs) during packets transmission Can you say why this is the case, and if this will be corrected or not?

I don’t believe this will be “corrected” as the beamforming happens in the moment and it would cause RSSI levels to yo-yo wildly to each SM as data is transferred. As mentioned, when beamforming is working, you can see on the radio’s performance page, the % of packets sent at the highest MCS rate ty…

[image] Eric Ozrelic: the beamforming happens in the moment OK, thank you Eric. I was thinking that with the 3000 AP we do see (I thought?) an increase in RSSI at the SM vs the 3000L without MuMIMO… but perhaps we don’t actually see that? Maybe I assumed so? And perhaps the 4500’s are a diffe…

Truth be told I’m actually speculating as to why they don’t show the change in RSSI. Maybe one of the devs can elaborate.

Cambium Community

[New Feature - 5.8.0] - AX Beamforming

Products ePMP

knowledge-base

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled