hi!
i have 5 pc connected to switch, abd the canopy is connected to it.!
the ip address of lan 1 is 192.168.1.xxx
the ip address of lan 2 is 192.168.1.xxx
the ip of canopy network is 169.254.1.xxx
and the internet address is 151.XXX.XXX.XXX.
the sm is in local!
the pc connected to lan 1 can see the file shared of lan 2 and
the pc connected to lan 2 can see the file shared of lan 1.
i can’t to see the pc from lan1 to lan2
to resolve the problem i must enable NAT from the advantage config?
can you halp me by step?
thank so much
ghina wrote: the pc connected to lan 1 can see the file shared of lan 2 and
the pc connected to lan 2 can see the file shared of lan 1.
That's ironic, because it was just what I was trying to make happen myself.
In terms of file shares, I think you can block those by going to each SM's Advanced Network Configuration page and checking the filter for SMB. But that would probably still allow some other TCP services to go between the LANs, which may or may not be what you want. (It is in my case.)
You may also want to make sure both the AP and SM's "Bridge Entry Timeout" is set to 25 minutes (the minimum). I didn't get my LAN segements to see each other until I increased that (the thread Jerry referenced), so if yours is higher than 25 you may want to decrease it and see what happens.
Doug