Point-to-Point ePMP1000 problem.

Hi all!

I've problem configuring two pmp1000 in bridge mode.

I have configured the two module with an ip outside the range used by the customer.

For the AP , configured as ePTP master the ip Address is 192.168.10.100

For the client configured as subscriber module as bridge with ePTP slave the ip address is 192.168.10.200

The customer network is 192.168.0.X/24 .

On side of subscriber module (ePTP slave) i have internet connection, that must be shared on the remote side ( where is the PTP1000 was configured as ePTP master).

I can ping both station without problem, but on the remote side (AP ePTP master) i have no internet,  and cannot see anything connected behind SM client.

The ePTP SM was configured in bridge mode.

Where is the problem?

Thanks a lot,

Giovanni.

To see both AP/SM first, you have to activate the local/remote management on AP/SM, that being said.
Bridge mode is totally transparent, I’ll bet it ain’t L2 problem, thus you should take a closer look into your L3 then we can proceed forward to it, if you need any help send me a PM (private message) with your mobile number (better if you use whatsapp on it).



Best Regards.

Kevin Cedeno F.
NPO and EPC Wireless Engineer
EWPE - Ericsson LTE Certified Engineer
MWFE - Motorola Wireless Field Engineer
Landline: +593 97-952-2253
Mobil WS : +593 98-896-8995
Landline EUA: +1 (518) 712-9466
Ecuador - Guayaquil
United States - California
Unless you try to do something beyond what you have already mastered, you will never grow.