R200 Partial Templates

I've successfully run configuration jobs with complete templates on the R200. I really like the function of this remote configuration ability.

I'm having trouble witih partial templates, though.

Earlier today, I setup a very basic partial template as follows:

SSID1=${SSID=Default WiFi}
WPAPSK1=${PSK=password1}

I tested the function earlier today. I'm relatively certain that it worked at the time. Now, however, I cannot seem to get these changes to be accepted. Starting a job using this template results in a "successful" job report, a reboot, but no changes to the configuration. 

There may be an error in the system preventing partial configuration changes on the R200... or perhaps I was mistaken with my earlier tests. Either way, what is the best practice for partial templates on the cnPilot series? 

Thanks - Chris

DBID_DBASE_Version needs to be incremented everytime new parital/full config is pushed.
For example if SSID1 need to be configured,then TxRate=0 and if it is for SSID2 then TxRate=0;0.

Samething needs to be followed for other parameters also.

Following are the parameters that need to be changed for R200 .


2.4 GHz parameters for SSID push
================================

DBID_DBASE_VERSION=1
BssidNum=3
TxRate=0;0;0
WmmCapable=1;1;1
NoForwarding=0;0;0
HideSSID=0;0;0
IEEE8021X=0;0;0
PreAuth=0;0;0
AuthMode=OPEN;OPEN;WPA2PSK
EncrypType=NONE;NONE;AES
DefaultKeyID=2;1;1
Key1Type=0;0;0
Key2Type=0;0;0
Key3Type=0;0;0
Key4Type=0;0;0
HT_MCS=33;33;33
RADIUS_Server=0;0;0
RADIUS_Port=1812;1812;1812
SSID3=SSID_Name
WPAPSK3=12345678

5 GHz parameters for SSID push
================================

DBID_DBASE_VERSION=1
RTDEV_BssidNum=3
RTDEV_TxRate=0;0;0
RTDEV_WmmCapable=1;1;1
RTDEV_NoForwarding=0;0;0
RTDEV_HideSSID=0;0;0
RTDEV_IEEE8021X=0;0;0
RTDEV_PreAuth=0;0;0
RTDEV_AuthMode=OPEN;OPEN;WPA2PSK
RTDEV_EncrypType=NONE;NONE;AES
RTDEV_DefaultKeyID=2;1;1
RTDEV_Key1Type=0;0;0
RTDEV_Key2Type=0;0;0
RTDEV_Key3Type=0;0;0
RTDEV_Key4Type=0;0;0
RTDEV_HT_MCS=33;33;33
RTDEV_RADIUS_Server=0;0;0
RTDEV_RADIUS_Port=1812;1812;1812
RTDEV_SSID3=SSID_Name
RTDEV_WPAPSK3=12345678