VLans over canopy

Hello,

I have not had luck getting more than one vlan over canopy working. Seeking you help please. Here’s my setup and config’s:

laptop----->SM------>AP-----Cisco(c2950)switch----->iSP

SM config:
Untagged Ingress VID : 1
Management VID : 1
Dynamic Ageing Timeout : 25
Allow Learning : Yes
Allow Only Tagged Frames : No

AP config:
Untagged Ingress VID : 1
Management VID : 1
Dynamic Ageing Timeout : 25
Allow Learning : Yes
Allow Only Tagged Frames : No

c2950 port config:
!
interface FastEthernet0/3
description Test port to Trunked-AP
switchport trunk native vlan 153 <— My AP is configured to a vlan 153 address.
switchport mode trunk
end

I cannot reach/ping the AP without setting the native vlan 10 153. The configuration source of the AP is set to SM. I can reach the internet fine when I configure my laptop to a Vlan 153 address, but not when I change to a different Vlan.
Am I doing this all wrong?
Many thanks in advance,

-Sal

Simply changing the “Untagged Ingress VID” of the SM to that of the customers vlan got this working …

-Sal