Defect Fixes (System Release 3.3)
Tracking |
Description / Workaround |
13516 |
[ePMP Elevate][XM] Spectrum Analyzer Support |
13638 |
[ePMP Elevate] Free default ePMP Elevate license (for registration of one non-Cambium ePMP Elevate-upgraded subscriber) |
13648 |
[ePMP Elevate][XM] Call-trace detected during upgrade from 3.2.1 to 3.3-RC1 |
13650 |
[ePMP Elevate] Web management interface incorrectly reports that the Ethernet status is “Down” |
13465 |
MCS Reporting Issue |
13558 |
Web management interface is not refreshed automatically after configuration has been restored |
13801 |
ePMP 1000 / ePMP 2000 Lite support for ePMP Elevate licensing/registration |
13789 |
SM WAN interface available for access when Separate Wireless Management IP is configured |
14029 |
No units displayed in SM Distance column in the Registered Subscriber Module table |
13475 |
IP Address not updated in Registered SM table on Monitor->Wireless page after disconnect DHCP Server |
14110 |
Improvements to MCS reporting on the web management interface |
Known problems or limitations (System Release 3.3)
Tracking |
Description / Workaround |
13238 |
[ePMP Elevate] ePMP Elevate devices are not supported by CNUT |
13346 |
[ePMP Elevate] Device name and network settings are not copied from original device configuration |
13299 |
[ePMP Elevate] Not possible to configure Uplink Max Rate to any MCS except 7th on single stream devices |
14016 |
After configuring the SM device into NAT mode and reconfiguring the WAN IP address, the Spectrum Analyzer tool is only available via previously-configured Bridge mode IP address |
14030 |
Unable to add new AP to Preferred APs table when in “Show Details” view. As a workaround, add new APs to the table when in “Show List” view. |
14131 |
[IPv6] AP and SM Separate Management Interface don't display obtained DHCP address on without manual refresh |