Does the cnPilot support the CLAT function in 464XLAT (RFC6877) including NAT64 prefix discovery as per RFC7050? Is there any documentation on special configuration?
I don't belive they support this. I very well could be wrong, but i haven't seen any low cost routers that support this. the only equipment I have that does in our Juniper MX routers...
my understanding of this RFC is another band-aid for IPv4 depletion allowing a carrier to move V4 blocks over V6 only routes removing the need for end to end v4 paths.
Hi
Currently, there is no support for ipv6 transition(464XLAT) in R-Series.
Regards
Niraj