AUTOMATIC channel selection

Hallo,

I started ACS on my Cambium AP in channel bandwith 40 MHz, and after 30 minutes is still running and no results. When I can see the results? I have to reboot the device or to chnage actual channel?

Thanks.

Typically, you enable ACS, then press save, then sometimes you can click the Run ACS and it will work, if the status doesn't say running, then you will most likely have to re-boot the radio first. When the radio reboots, it will first perform an ACS, and then set the channel. If you want to see the results, just go back to the ACS page and you should see a graph there already along with the channels that it picked.

1 Like

Ok, I will do like you sad. First time I did not reboot the radio unit. Thanks.

It works, now I can see the graphic!

Thanks!