There is something I don’t understand yet.
BH20 means 20mbits over the air.
14mbits ethernet. In Downlink Data set to 50% that means 7mbits up and 7 down.
Why I am only getting 3.5mbits ? From my SM Advantage to the office ?
I never have 7mbits
2.4 SM ADV ----- 2.4 AP ADV ----- BH20_Slave ------ BH20_Master ---- OFFICE
Stats for LUID: 2 Test Duration: 2 Pkt Length: 1522
Downlink RATE: 6954496 bps
Uplink RATE: 7372800 bps
Downlink Efficiency: 100 Percent
Max Downlink Index: 100
Actual Downlink Index: 100
Expected Frag Count: 27166
Actual Frag Count: 27166
Uplink Efficiency: 100 Percent
Max Uplink Index: 100
Actual Uplink Index: 100
Expected Frag Count: 28800
Actual Frag Count: 28800
LUID: 002 : MAC: 0a-00- State: IN SESSION (Encrypt Active)
Site Name : Backhaul Slave
Software Version : CANOPY 7.3.6 Oct 24 2005 12:06:56
Software Boot Version : CANOPYBOOT 3.0
FPGA Version : 020205 (DES) P9
Session Timeout: 10, AirDelay 1254 (approximately 11.64 miles (61446 feet))
Session Count: 1, Reg Count 1, Re-Reg Count 0
RSSI (Avg/Last): 1111/1100 Jitter (Avg/Last): 5/6 Power Level (Avg/Last): -59/-59
bump!
cause it is 7 mb aggreate 3.5 up and 3.5 down if it is a regular ap and sm if it is a true BH20 then i am not sure maybe you should check and make sure it is in hardware scheduling mode.
kmeadows
the BH is a 20mbits.
it’S in software scheduling. version 7.3.6
in hardware sched i see a big drop in latency and bandwitdth.
According to your test the BH’s are not the issue. What about the AP to SM link? What does the link test look like?
This is a link test from the SM Adv.
This one is fine too. AP and BH are set to 50%
I can’t understand why i only see 3.5mbits MAX.
From SM to Office
Stats for LUID: 49 Test Duration: 2 Pkt Length: 1522
Downlink RATE: 6925824 bps
Uplink RATE: 5840896 bps
Downlink Efficiency: 100 Percent
Max Downlink Index: 100
Actual Downlink Index: 100
Expected Frag Count: 27054
Actual Frag Count: 27054
Uplink Efficiency: 100 Percent
Max Uplink Index: 100
Actual Uplink Index: 100
Expected Frag Count: 22816
Actual Frag Count: 22816
What method or procedure are you using to determine the speed? What about the cabling between the BH and AP? What is between the two? Have you run your test from that location ?