cnMatrix VLAN, Access/Trunk ports config with Cisco core router & switch

Products cnMatrix
4

Hello,

Here are the CLI commands to configure cnMatrix:

Switch(config)#int vlan 1 

Switch(config-if)#ip add 10.1.10.5 255.255.255.0

Switch(config-if)#no shut

Switch(config-if)#exit

Switch(config)# ip route 0.0.0.0 0.0.0.0 10.1.10.1

-Create VLANs

Switch(config)#vlan 20

Switch(config)#vlan 30

Switch(config)#vlan 40

-Trunk/Access Ports:

Switch(config)#int gig 0/1

Switch(config-if)# switchport acceptable-frame-type all

Switch(config-if)# switchport mode trunk

Switch(config-if)#int gig 0/2

Switch(config-if)# switchport acceptable-frame-type untaggedAndPrioritytagged

Switch(config-if)# switchport mode access

Switch(config-if)#switchport access vlan 20

Switch(config-if)#int gig 0/3

Switch(config-if)# switchport acceptable-frame-type untaggedAndPrioritytagged

Switch(config-if)# switchport mode access

Switch(config-if)#switchport access vlan 30

2 Likes