I have a ePMP 5GHz integrated with 1.1-r10 installed.
The CPU stat on the Dashboard is pegged at 100%. No clients connected.
Does not clear on reboot.
Is this a interface bug? I have some conectized 2.4 running 1.1.a4 and the CPU stats seem fine.
Martin
This happened to me as well after I upgraded the firmware on the radio a number of versions. I had to reset to factory defaults and then all was well.
Just tried that and it did clear.
Thanks!
Spoke to soon.
Back to 100% again :(
Curious, so you reset it to factory defaults and the issue seemed to go away... did you then reconfigure it and then shortly thereafter it was showing 100% utilitzation?
Yes.
Even when I just reset it, the CPU running above 50%.
Added some VLAN's, configured 3 WLAN's and it started jumping up to 85%.
With a few minutes it hit 100% and stayed there.
Can you SSH into the radio and run the command top from the CLI? Can you post a screen shot of this? Thanks!
The command is "service show top"
1487 1486 root R 1540 2% 100% /bin/gzip
21270 1 root S 4324 7% 0% /usr/sbin/device-agent -d2 -shttps://cloud.cambiumn
1344 1 root S 4216 7% 0% /usr/sbin/wifid -d
760 1 root S 4040 7% 0% /usr/sbin/scmd -d
1362 1360 root S 3820 6% 0% /usr/sbin/lighttpd -f /etc/lighttpd/lighttpd.conf
1361 1360 root S 3820 6% 0% /usr/sbin/lighttpd -f /etc/lighttpd/lighttpd.conf
1360 1 root S 3776 6% 0% /usr/sbin/lighttpd -f /etc/lighttpd/lighttpd.conf
763 1 root S 3700 6% 0% /usr/sbin/snmpd -f -c /etc/snmp/snmpd.conf -p /tmp/
425 32739 root S 3652 6% 0% -clish
761 1 root S 1560 3% 0% /usr/sbin/infrad -d
32739 775 root S 1308 2% 0% /usr/sbin/dropbear -F -I 300
1486 5 root S 1308 2% 0% {zip_corefile.sh} /bin/sh /usr/bin/scripts/zip_core
1488 425 root S 1308 2% 0% /bin/sh -c /usr/bin/top -n1
1 0 root S 1304 2% 0% init
1489 1488 root R 1304 2% 0% /usr/bin/top -n1
764 1 root S 1304 2% 0% /sbin/getty -L ttyS0 115200 vt100
631 1 root S 1300 2% 0% /sbin/klogd -n
630 1 root S 1300 2% 0% /sbin/syslogd -n
759 1 root S 1296 2% 0% /usr/sbin/sysmond -d
775 1 root S 1244 2% 0% /usr/sbin/dropbear -F -I 300
638 1 root S 780 1% 0% /usr/sbin/rngd -r /dev/urandom
This issue is fixed in release 1.6 (will be shortly in Beta)