Dear Team How can I know if an epmp 2000 Base radio is been over utilized during operational? I have bought and uploaded the license key such that it has the capability to accept 120Subscriber modules. But currently it has just 11customers on it. [image] [image] But how do i know when the bas…

Hi, Downlink Frame Time will provide you the sector utilization in % [image]

Hello Thanks a lot for your prompt response. Currently what I have on the base radio is that it varies from 95% to 100% [image] So with this Total frame Time used what will be the effect if I should add more subscriber modules into the base radio?

Total link bandwidth you have now will be divided between all subscribers. Old and new ones.

[image] KOwopetu123: the base radio is that it varies from 95% to 100% Hi. In an above image, you showed that your Monitor → Throughput Chart… and that shows an average of 11 to 14Mbit. If you are only getting 14 Mbit and 100% frame time used – then you have something(s) wrong. You should …

Single Base radio with 12customers.docx (1.1 MB) Dear Team Thanks for your responses to my mail. Kindly find attached the screens shots of my base radio in question… How else can I better optimize this Base radios performance. Finally when can I know when my base radio is over utilized? Is this…

Ninedd was right. You have multiple subscribers showing high transmission rate. Normal level is 3% or below. This can be due to low SNR of those subscribers. At the same time RSSIs are good. Can you check the frequency with Spectrum Analyzer for interferes?

Cambium Community

Epmp 2000 Base radio

Products ePMP

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled