ePMP force 200 appears to be stuck in a boot loop.

Hello There,

I have an ePMP force 200 with firmware revision 3.5.2, that appears to be stuck in a boot loop.  I have already tried a factory reset of the device, but it appears that once plugged in, it will lose link every 5-7 seconds.  Should I contact support for an RMA, or is there some way I can bring this thing back from the dead?

Please try to recover it through following recovery procedure:
http://community.cambiumnetworks.com/t5/ePMP-Troubleshooting/Recovery-of-flash-corrupted-ePMP-devices-caused-due-to-power/m-p/54712

Thank you.

1 Like

That did it.  Thank you very much.

1 Like