PMP 450i default plug

[RP1 (RP)]

Can anyone send me the pinout for the 450i SM default plug? I realized this model has an 8-pin ethernet port in the place where the older Rugged High-Gain models had a 6-pin port. I built cables for tone using the 8-pin, but haven’t found the default plug pin-out–the older RJ-12 ports used pins 4 & 6 for the default plug.

Thx!

[Simon_King]

Does this post help at all?

How to Enter Default Mode or Recovery Console for 450b, 450i and 450m series products

For 450b, 450i and 450m, the process to enter the Recovery Console (formerly called Default Mode) is different than it was for prior products (including PMP/PTP 100, 430 and 450 -- the procedure for the "Default Plug" to enter Default Mode on those products can be found here). To Enter the Recovery Console on 450b, 450i or 450m based products (including the 900 MHz 450i Access Point): 1) Apply power to PSU for at least 10 seconds. 2) Remove power for two seconds. 3) Re-apply power to the PSU…

[RP1 (RP)]

Thanks! I’ll give this a try.

[CambiumMatt]

Yeah, just to follow up… there is no “default plug” for 450i. That method was replaced by “Recovery Mode” as outlined in the post that Simon links to above.