Problem with access control panel

[CambiumMatt]

If the IP address is configured to be something other than the default IP address (which is what you list above), you have a couple of options to obtain access to the SM.

First, if you know the IP of the Access Point it connects to, and can reach that device, you can view all of the SMs connected, and reach the SM using the AP Proxy.

Second, you can enter recovery or default mode on the SM itself if you have physical access to it. Instructions for this are here:

How to Enter Default Mode or Recovery Console for 450b, 450i and 450m series products

For 450b, 450i and 450m, the process to enter the Recovery Console (formerly called Default Mode) is different than it was for prior products (including PMP/PTP 100, 430 and 450 -- the procedure for the "Default Plug" to enter Default Mode on those products can be found here). To Enter the Recovery Console on 450b, 450i or 450m based products (including the 900 MHz 450i Access Point): 1) Apply power to PSU for at least 10 seconds. 2) Remove power for two seconds. 3) Re-apply power to the PSU…

If you have an original 450 SM, a default plug can be inserted into the timing/default port, per the instructions here:

How to Default a PMP Device?

We advise to use a default plug on the RJ11 port, reboot the device, and access this device using IP address 169.254.1.1, using the network card on same IP range (ex: IP: 169.254.1.5 and MASK: 255.255.0.0).