I currently have a PTP-850s link setup at around the 50KM range mark. Signal is down around -42 and holds very steady at that point.
Issue I am seeing is that I am only getting a max of 15Mbps link capacity. When doing a speedtest via the link I get the same speed.
Any help would be greatly appreciated.
What MRMC script are you using? What modulation and TX/RX bit-rate is being achieved on the MRMC Status page? Are both radio’s ethernet ports negotiating at full speed? What firmware revision are the radios using? The newest stable revision is 12.0.
Hello Mr. @Andrew_Holliday ,
can you send a screen shot of the MRMC status?
Sincerely yours,
Niragira Olympe
Hello Mr. @Andrew_Holliday
PTP 850S-DATA AND MANAGEMENT VLAN CONFIGURATION.docx (189.2 KB)
Find attached the procedure for the PTP 850S inband management. I tested it on several PTP 850S radios and it works well.
Let me know if it works for you. You should at least be used to the PTP 820S in order to achieve this very easily.
If you meet any other issues, let me know and I assist you remotly.
Sincerely yours,
Niragira Olympe