R200 Automatic repush config after customer reset

If the router boots up and the config has changed from centrally managed cnMaestro, we would like the config to be repushed out  to the router after a 30 second delay.

This is so if a customer resets the router, it will automatically reconfigure itself.

A small delay allows a technician time to get in and cancel the repush

Any update with this? I see there is an “Out of Sync” notice on the device configuration page but no automatic re-push (unless its too obvious for me to see) Eg we want to remove a voice line from a router while it is powered off. When it powers back on it should sync without us having to manually click sync now.