Release 4.1.3 is now available for the PTP 550

Products PTP
1

 

 
Release 4.1.3 is now available for the PTP 550
 

 

2

Hi, after upgrade to 4.1.3 the second radio is not comming up on PTP550. Second radio on Slave remains in scanning and doesnt even see the signal to connect, while in Master the second radio is UP. First radio is normally connected with signal -58dBm. Distance is 21Km.

3
@someone wrote:

Hi, after upgrade to 4.1.3 the second radio is not comming up on PTP550. Second radio on Slave remains in scanning and doesnt even see the signal to connect, while in Master the second radio is UP. First radio is normally connected with signal -58dBm. Distance is 21Km.

Could you please disable Channel bonding on Slave and then Master side and then enable it again on both ends?

Thank you.

4

Just did it but nothing changed, same issue.

5

Any news about 4.1.4 beta software? When it will be avalible in beta section?

1 Like
6
@carlosmilek wrote:

Any news about 4.1.4 beta software? When it will be avalible in beta section?

It's there now.  I am using 4.1.4-RC4 on our Force300's and (so far) with pretty good results. :) 
http://community.cambiumnetworks.com/t5/ePMP-Beta/ePMP-Beta-Release-4-1-4-RC4-is-now-available-for-the-ePMP-Force/m-p/95973/highlight/true#M1105

1 Like