Tony_So
(Tony So)
March 11, 2021, 2:11am
1
For some users, they do not allow any connection to the cloud. Is it possible to set up the cnWave V5000, V3000 and V1000 directly using a PC without using the cnMaestro if user does not have any cnMaestro on VM server ?
Hi Tony,
You can use onboard controller and onboard NMS. A maximum of 21 node cnWave mesh can be setup this way. 21 nodes include PoP node.
Please follow these Knowledge base articles
A Terragraph mesh topology is based on a layer 3 IPv6 network, cnWave radios support IPv4 using layer 2 tunnel.
When Layer2 bridge is enabled on nodes, each node forms a Layer 2 tunnel with POP and transports user traffic. Downstream CPE devices get the IPv4 address from the DHCP server running on the service provider’s network.
PTP V5000-V5000 test setup:
[image]
Prerequisites:
PC connected to POE interface of V5000 (to be acting as POP) via a switch.
The DHCP server should be runnin…
Tony_So
(Tony So)
March 11, 2021, 3:00am
3
Thanks a lot for clarificaiton.