Static VLAN Pooling on E-Series

Static VLAN Pooling is now a supported on CnPilot E-series devices.

Note: This feature is available from 3.4.3-r1 release build.

Prerequisites for Static VLAN Pooling

A VLAN should be present on the AP to be able to add it to the VLAN pool and static vlan pool name should be configured on Access Point WLAN configuration.

Restrictions for Static VLAN Pooling

The number of VLAN Pools on the AP should not exceed value of 16.

The number of VLANs mapped to a VLAN pool is not limited. But it is the responsibility of the administrator to configure feasible number of VLANs in a VLAN pool.

For expected behaviour of the VLAN pooling, the VLANs mapped in the pool must be present on the AP.

Information About VLAN Pooling

Whenever a wireless client connects to a wireless network (WLAN), the client is placed in a VLAN that is associated with the WLAN. In a large venue such as an auditorium, a stadium, or a conference room, university where there are numerous wireless clients, having only a single WLAN to accommodate many clients might be a challenge. The VLAN pooling feature uses a single WLAN that can support multiple VLANs. The clients can get assigned to one of the configured VLANs. This feature maps a WLAN to a single VLAN or multiple VLANs using the VLAN pool. When a wireless client associates to the WLAN, the VLAN is derived using round-robin algorithm. A VLAN is assigned to the client and the client gets the IP address from the assigned VLAN.

Note: In 802.11R roaming and OKC, when client roams from one  AP to other AP, it maintain same IP address and it provide seamless roaming in VLAN Pooling also.

How to Configure Static VLAN Pools

Creating VLAN Pools (CLI)


Removing VLAN Pools (CLI)


Creating VLAN Groups (GUI)

Enable  Static VLAN Pooling to WLAN (CLI)

Enable  Static VLAN Pooling to WLAN (GUI)

See VLAN Pooling Distribution (CLI)

To use Radius based VLAN pool where Radius provides pool name to AP. Please follow below link.