Syslog message: get table: PER_STA: empty block, ignore

Platzhirsch · May 4, 2018, 6:50am

it is epmp 1000 GPS AP. what does this mean: get table: PER_STA: empty block, ignore

rhett · May 11, 2018, 1:52pm

I also have this question.

Fedor · May 11, 2018, 2:01pm

@Platzhirsch wrote:

it is epmp 1000 GPS AP. what does this mean: get table: PER_STA: empty block, ignore

Hi,

Could you please attach system log file where you observed this sting?

Thank you.

cbonilla · July 4, 2018, 1:42pm

attached you will find the requested syslog file

system_log.txt (1.72 KB)

jperez · July 6, 2018, 3:56pm

I have the same issue, any sugestion?

system_log.txt (1.19 KB)

Orlov_Gennadii · August 25, 2018, 7:45am

I have the same issue, any sugestion?

system_log.txt (5.7 KB)

Andy_Rosen · September 3, 2018, 5:05pm

I am seeing this also. In my case, it's an older PTP110 running 3.5.2 software.

MarioUlio · September 4, 2018, 2:44pm

Same Issue in all my AP´s since 3.4.1 version.

ziplinksystems · July 11, 2019, 3:36pm

Did anyone find an answer to this? Are you guys running LibreNMS by chance? The log entries are 5 minutes apart - the same as my LibreNMS polling interval.