updating a BH

Products PMP
1

I have a back haul that happens to be on version 4.2.1.

I have read that 6.1 is my next step, and then I can go 7.x to 7.x etc…

How can I get to 6.1? I have all the available software for cnut 2.0 and the earliest is a 7.x version.

BTW, everything else on my net is at 7.2.9. once I get this one to that point, I can begin updating my whole network (bit nervous… but we’ll get’er)

Thanks.

2

You will need CNUT 1 for this.

ftp://canopy:canopypass@digitron.on.net … upCNUT.exe

ftp://canopy:canopypass@digitron.on.net … 61_DES.pkg

From there you can continue with CNUT2.

3

Hey!


You might want to solicit some advice about which is the best firmware for your backhauls: The last I had heard the most stable was 7.1.4 (that’s what ours are at, though the rest of the network is 7.3.6). There’s probably a couple of threads on this forum, as I know it’s been a topic of discussion in the past.

4

True, My version is very stable, but my main need is to gain the 1000 pps that the new version has been said to bring. I am LOADED at my current position. I’m up for anything that will work :slight_smile:

5

What new version will bring 1000 pps more? Only BH P10 can do 4000 pps with software version 8.2.

I don’t plan to upgrade my P9 BHs for anything other than 7.1.4 for the time being.

6

so even a P9 updated to 8.2.x will not provide that benefit?

Also, how might I check my hardware version then? Can I do it web, or need to telnet?

Thanks for your help.

7

Highly recommend you sniff your network for multicast and P2P traffic eating up your PPS capability.

8
LP wrote:
so even a P9 updated to 8.2.x will not provide that benefit?

Also, how might I check my hardware version then? Can I do it web, or need to telnet?

Thanks for your help.

.
P9 - 3000 pps. So, you do it with 7.1.4.

So, if you are in America you probably don't have P10 yet. You can upgrade it to 8.x and on the first page you will have the board type...

P10 come only with 8.x software so I guess that's the best way to tell.
9

I remember the time that we were waiting for the 6.x version of software. Moto were promising better latency and we were thinking that only software will change things for the better.
Unfortunately that wasn’t the case. We were spoused tho buy P9 board which do ‘advantage’. I can’t deny it that this was huge step forward for Moto, but this story is coming again in small door. We have to upgrade our advantage APs to P10 if we wanna do 4000 pps, and that’s bullsh*t!

So when P11 comes by what is the next thing?

10

Moto Turbo… or Turbo AP…doubles the capacity of advantage Ap(i heard)