Hello Matteo,
I’m glad the factory default got you back in to a working state, but I’m surprised the upgrade put you in an odd state.
Could you explain what condition the units where in before you upgraded, had you been using these in the lab or configuring these before hand. I’ll have the team try to reproduce the fault but knowing the state would be useful.
BTW to setup a PTP link, whether it’s a V3000, V2000 or V1000 an easy way to do this is use the Quick PTP setup option.
All you need is the ESN of the client end, login to the radio that will become the controller and go to Tools > Quick PTP Setup and enter the ESN (MAC address) of the other radio.
Then hit the “Start PTP SetUp” button.
Once the radio reboots it will automatically do the following:
Enable the E2E controller
Enable Layer 2 bridging
Create the Client information and Create the Site / Nodes / link (you can edit these later)
Once you power up the Client (no configuration needed) the link will be formed and the configuration downloaded from the controller.
The Controller will have the default IP address 169.254.1.1. and the Client 169.254.1.2, of course you can change these once the link is up.