macgyver
(macgyver)
March 24, 2021, 3:09pm
1
Is there a way to factory reset a v5000 without being able to access the GUI
Are you able to make a wired connection directly to the device and access the Recovery Mode GUI?
Recovering a cnWave60GHz device – Forgotten IP address / Forgotten password / Factory Reset
For situations with cnWave60GHz platforms when connectivity has been lost and so they cannot be managed, there is a Recovery Mode available that can restore control.
Recovery Mode requires a direct connection to the unit; only the wired/fibre connections are available for recovery.
Preparation:
A portable device (e.g. a laptop) is required to run a web browser to connect to the Recovery Web-GUI. Per…
This works, definitely took a few tries. I left a ping going and then finally got through on microsoft edge only, then chose to boot into recovery mode. after that it was all good.
Antony
(Antony)
March 24, 2021, 9:19pm
5
The short reset takes a little getting use to but it does allow you to recovery units which you may not be able to physically reach.
Simon_King
(Simon King)
Split this topic
March 3, 2022, 9:38am
6