We have lost the ability to rate limit WLANS after upgrading to Version 2.1.1-r14 onsite.

Products cnMaestro
1

Prior to the upgrade, the rate limiting was pretty accurate.  After the upgrade, we seem to have lost the ability.  Has anyone else experienced this? 

We are using e700, e600, and e400 access points.  They are all running 3.10.1-r2 firmware. 

2

Could you please share tech-support of any AP.

Thank You.

3

hi,

does rate limit is done on ssid or from cnMaestro captive portal policy.

4

It is done on the ssid.   

WLAN--> Configuration--> Access Control--> Rate Limit per Client.  

5

we also same problem , after upgrading firmware 3.10.1-r2 our all e400 aps user limit is not working , please help me any one about this problem

6
@johnZnetworks wrote:

we also same problem , after upgrading firmware 3.10.1-r2 our all e400 aps user limit is not working , please help me any one about this problem

Is the AP configured to do NAT for the wireless traffic or is it only bridging traffic?

7

bridging traffic

8

Hi,

Can you please tell which security type you are using in WLAN. (open/wpa2-psk/wpa2-Enterprise).

Please send techsupport dump of AP to divakar.clement@cambiumnetworks.com

Thanks,

Divakar